PE 1016 Fluidizing Jet-Flow™ liner with shaped discharge tube (pat.
pend.)
Suitable for: Hard flowing products.
The Jet-Flow™ consists of a perforated
semi-rigid tubing positioned inside the liner in specific areas. The free
end of these tubes located outside the liner is connected to pressurized
air (or other gas) source throughout the unloading. The perforation made
in the pipes will spray air jets up to 20cm from the hole in the tube.
Using a liner equipped with Jet-Flow™
Fluidizing System increases the range of products being suitable for transport
in a dry bulk liner. Discharge of products which can be fluidized becomes
as easy as any other free flowing products.
The Jet-Flow™ system can also be used
to reduce the discharge time for “hard to flow” products that
are currently being shipped in dry bulk liners.
Specifications:
Made for 20' , 30' and 40' containers.
For 20' liner: 2400 x 2400 x 5900 mm.
Discharge tubes are made according to customers requirements;
fishtail shape or mail box.
Material:
Co-extruded 3-layer Polyethylene(PE)
150-200 microns(6-8 mil), FDA approved
Reinforcement bulkhead Polypropylene (PP) coated.
Loading:
Horizontal loading through loading tube in bulkhead.
Unloading:
Connect discharge tube with wide "fishtail" shaped discharge
spout or other suitable discharge equipment. The container is tilted,
and transfer of bulk to silo is done by using gravity/air, pump
or pneumatic system.
Retention of bulkhead:
The liner shall be used in connection with retention bars, mounted
at the container opening (bulkhead).
|
Download
Brochure
|
To use Jet-Flow is as simple as "plug and blow"
|
 |
|
